Possible to split ip block?
I think you can only route the whole block to another server, not single IP within the block.
ozgurerdogan
28-10-2014, 09:53
Originally Posted by
Neil
Hi
It is not possible to split a block and route to multiple servers.
Not route to multible servers only to a different server in case of current server is failed. So what must I do then to only forward certain ips to different sys server? Cancel ips and re-order smaller blocks?
Hi
It is not possible to split a block and route to multiple servers.
ozgurerdogan
28-10-2014, 08:42
Originally Posted by
vm1990
iv never order a block of ips but dosnt it show up as 16 ip addresses in the so you start control panel? id so then there the same a fail over ips just need to assigne them each a mac address and your sorted
Yes from sys panel. Problem is I can failover only whole block. Not a smaller ip or single ip.
iv never order a block of ips but dosnt it show up as 16 ip addresses in the so you start control panel? id so then there the same a fail over ips just need to assigne them each a mac address and your sorted
ozgurerdogan
25-10-2014, 19:38
I ordered 16 ips and they are activated. But it is one block. I will need to use failover for some of them. Can you split block?